What is return bend?

Return Bend is a type of pipe fitting that changes the direction of passing fluid by 180 degrees. It is u-shaped and made up of two L-bends. The fitting can be mold or cast as per the requirements of the existing pipe. As it is widely used by plumbing supplies thus it is available in […]

 
Read More

What is reducing tee?

What is reducing tee? A Reducing Tee is a T-shaped pipe fitting with two outlets that cut at 90 degrees to the main line. These tees are available with a combination of diverse outlet sizes. In this, the branch port size is smaller than the other ports of the run. Before buying a Reducing Tee, […]

 
Read More

What is reducing elbow

Reducing Elbow is a kind of elbow setting that provides a change in the material flow and joins two pieces of different pipes or tubes. It helps the system to avoid pressure losses due to re-acceleration and friction. It is named so as it designed like an elbow. It has different sized openings depending on […]

 
Read More

What is orifice plate?

An Orifice Plate is an instrumentation device which is used for measuring the gas or liquid flow rate, reducing the pressure of flowing fluid or gas, and restricting the flow rate. The device is mainly used when the transfer of hydrocarbons from one entity to other entity has to take place. Sometimes an orifice plate […]

 
Read More

What is a pumping unit?

A Pumping Unit is an overground drive that is used to reciprocate a piston pump in and out of an oil well. The pump is used to lift oil mechanically, especially if the bottom hole pressure is not high enough to make the oil to flow to the surface. It is basically used on onshore […]

 
Read More

What are the safety tips of pipe fittings

As pipe fittings are used in various applications involving slurries, gas, liquid, corrosive substances, mud, chemicals etc., it is essential to follow certain safety tips for proper functioning of these fittings when fitted to various pies. According to an article published recently, some safety tips that can be followed are as follows: Fumes are present […]

 
Read More

Why do we have to recycle brass fittings

Brass pipe fittings are much more expensive than its equivalents. Some times it may cost ten times more than the plastic or steel fittings. So before you make a decision to replace your old pipe fittings, just think once. Something that can be done to recycle your cruddy and tarnished fittings. A little scrubbing and soaking […]

 
Read More

What is the future of pipes and pipe fittings industry

Thanks to the large-scale construction and development activity in the recent past, the pipes and pipe fittings industry is a rapidly growing industry. Pipes are essential for connectivity, be it for water supply inlets to provide for clean and waste water distribution systems, agricultural watering system, liquid discharge installations, water sprinkling and dropping systems, sanitation […]

 
Read More

The Standards Of Pipe Fittings

The Standards Of Pipe Fittings Affecting Factors Types With the rapid expansion in the global trade, standardization of various products has become an essential requirement. The standards given to various products significantly contributes towards increasing international trade which in turn bridges the quality gap between the manufacturers, producers and buyers of different nations. In pipe […]

 
Read More

How to selection pipe fittings

The Selection Guide Of Pipe Fittings Types Selection Criteria Pipe fittings are available in various shapes, sizes and materials. Used to connect pipes of different lengths and sizes, these pipe fittings and flanges should make the right connections. Pipe and pipe-fittings are produced from a various materials for the transport of wide variety of solids and […]

 
Read More